A base must be constructed for the new/large CNC Router. There has been an offer to help construct a wooden base out of 4x4 material and there was mention of helping weld up legs. Either way, I figured this would be a good place to have a conversation about how to move forward on this.
The metal legs that I was using in my garage are at the Hack Factory, but I have very limited welding experience, and will not be able to assist much in this option. If this is the desired route, I will need some help/suggestions. If the wooden base is going to be constructed, let me know how to help. I also have some castors I can pull of the original base when I go home for Thanksgiving.
What should we do?