A couple of weeks ago I posted an invitation to join my effort to build a musical bench of PVC. Thank you to TC Makers Becca, Bill D, Bob G, Colleen, Jon, McSteve, Roxanne, Scott and Shawnuk for their generous help over the past 2 weekends.
Because of them I now have a paddle prototype, 4 sections cut, 2 sections in welding progress and one section complete!
My original plan was to have the bench finished by last night—not even close! Several complications arose as we started to build:
1. Two circles = 0 surface area
Fellow TC Maker, Steve M, pointed out to me that before I began solvent welding, it would strengthen the bond if I increased the surface area where each pipe intersects.
I tried using the band saw to shave off some of the pipe exterior and flatten the places where each pipe meets another but that was really messy and slow.
Bill D generously made a jig for me to use with a router which tremendously speeded the process back up.
2. Four inch diameter pipes are not musical
My friend Shawnuk stopped by the Hack Factory to help me work out details before I geared up to start building. As soon as he saw my 4” diameter pipe samples, he pointed out that they would have to be much taller than bench height in order to make a musical note.
We tested this out and he was right. Luckily, I had purchased only one pipe. Recognizing that a 2” diameter pipe would probably work, I had to re-draw my design in Sketchup. In order to keep the bench reasonably large, I now need to solvent weld 270 pieces!
3. Welding pipes takes TLC
TC Maker, Colleen, can solvent weld better than anyone else I know. She showed me that although bungee cords and rubber bands can be helpful to hold pipes together as they dry, as the welded section grows there is no substitute for just holding the pipes in place until they are dry enough to stand on their own. This really slows the overall process when I am working alone.
Please stay tuned for future volunteer opportunities!