Hey thanks for checking out my blog!
MPR aired a nice story today on the bench but cut out all 3 of my mentions of Twin Cities Maker at the Hack Factory. Kind of a bummer.
At least in this short TPT piece you can see the back of my Twin Cities Maker T-shirt!
Thanks for checking out my blog post! As I promised in last week’s entry, this week I will reveal whether or not I solved Frank Lloyd Wright’s design problem. The Origami Chair famously has a tendency to tip forward; especially as the sitter scoots forward in preparation for standing up. Wright’s solution was to add anti-tipping feet; he added metal caps to make the extra pieces look more intentional.
My thought was to make the front feet larger, providing a greater surface area and, therefore, a lesser proportion of the sitter’s weight on the front corner of the feet. Good idea?? I originally made the feet about 4″ long (a 25% increase from the FLW model) and then sliced off a couple of inches from the bottom of each side of the chair, doubling the length of the feet. Result??
I still had a tipping problem. The seated person wasn’t in any danger but the experience of getting up from the chair could still be a bit startling–not a desirable quality for a chair!
I considered tossing the chair out and moving on to another project until a fellow member of Twin Cities Maker mentioned that a chair with a tipping problem might make a great rocker. Thus began a new design!
So, next I carved a model rocker out of polystyrene foam.
Determining the arc of the rockers turned out to be quite a research project. Eventually, I found a simple formula for finding the length of the radius of the circle from which the arc should be drawn. That is seat height x pi. I brought my model and 2 tubes to a steel-bending expert.
Next, I made several steel plates to screw to the feet and tail of the chair so that I could connect the chair to the rockers.
Positioning the chair, just right, onto the rockers was challenging. If there is a next time, I will get help holding the chair as I weld it to the rockers.
Next week, I will discuss creating the exterior of the chair.