Tag: sculpture

Musical PVC Bench in the News!

Posted on by oldpostholder in Events and meetups, projects
A worker in downtown St. Paul takes a break on my bench during the September, 2013 display.
A worker in downtown St. Paul takes a break on my bench during the September, 2013 display.

Hey thanks for checking out my blog!

MPR aired a nice story today on the bench but cut out all 3 of my mentions of Twin Cities Maker at the Hack Factory.  Kind of a bummer.

At least in this short TPT piece you can see the back of my Twin Cities Maker T-shirt!

 

Origami chair redesign: fixing FLW’s problem?

Posted on by oldpostholder in Minne-Faire, Posts, projects, Woodworking

Thanks for checking out my blog post!  As I promised in last week’s entry, this week I will reveal whether or not I solved Frank Lloyd Wright’s design problem.  The Origami Chair famously has a tendency to tip forward; especially as the sitter scoots forward in preparation for standing up.  Wright’s solution was to add anti-tipping feet; he added metal caps to make the extra pieces look more intentional.

This photo provides a good view of FLW's anti-tipping feet. They are the pieces of ply with the metal tips.
This photo provides a good view of FLW’s anti-tipping feet. They are the pieces of ply with the metal tips.

My thought was to make the front feet larger, providing a greater surface area and, therefore, a lesser proportion of the sitter’s weight on the front corner of the feet.  Good idea??  I originally made the feet about 4″ long (a 25% increase from the FLW model) and then sliced off a couple of inches from the bottom of each side of the chair, doubling the length of the feet.  Result??

I still had a tipping problem.  The seated person wasn’t in any danger but the experience of getting up from the chair could still be a bit startling–not a desirable quality for a chair!

I considered tossing the chair out and moving on to another project until a fellow member of Twin Cities Maker mentioned that a chair with a tipping problem might make a great rocker.  Thus began a new design!

So, next I carved a model rocker out of polystyrene foam.

Here the foam rocker is taped to the table to approximate how it would look once attached.
Here the foam rocker is taped to the table to approximate how it would look once attached. The paint chip that I have taped to the side is a color I considered for the chair.

Determining the arc of the rockers turned out to be quite a research project.  Eventually, I found a simple formula for finding the length of the radius of the circle from which the arc should be drawn.  That is seat height x pi.  I brought my model and 2 tubes to a steel-bending expert.

One of my rockers is finishing its final bend. This machine has a limit of 2 in diameter metal.
One of my rockers is finishing its final bend. This machine has a limit of 2 in diameter metal.

Next, I made several steel plates to screw to the feet and tail of the chair so that I could connect the chair to the rockers.

Positioning the chair, just right, onto the rockers was challenging.  If there is a next time, I will get help holding the chair as I weld it to the rockers.

I propped the chair just as I wanted it to sit on the rockers so that I could design the hardware to connect the front feet. You can see on the left that I used a plate welded to a square rod to connect the tail.
I propped the chair just as I wanted it to sit on the rockers so that I could design the hardware to connect the front feet. You can see on the left that I used a plate welded to a square rod to connect the tail.

 

Next week, I will discuss creating the exterior of the chair.